Watchguard template doesn't detect IfDesc

[sjackson0109]

All my 'network Interfaces are labelled $1. This is because the Watchguard Community Template

If I walk
1.3.6.1.2.1.2.2

I get this OID, for an indexed list of interface descriptions:
1.3.6.1.2.1.2.2.1.2

Guessing we might need to do some pre-processing steps; but i don't really know enough about what i'm doing.

Any tips/advice?

I REALLY would like to know which Physical/VLAN/VPN interface name has gone down and not 'device xxx interface $1 offline`. Without the interface label, the template is useless.

[sjackson0109]

If anyone is interested i've made a vastly improved version, based on the Watchguard MIB files, if people show an interest i might also share it in the community repo.

Available here: https://github.com/sjackson0109/ZabbixTemplates/blob/main/templates/watchguard_firebox.yaml

description: |
## Overview
Complete Template for monitoring Watchuard Firebox Firewalls.

    ITEMS:           
    - Basic Info: Uptime, Device Name, Model, Location, Description, Firmware, Ping, Latency, Packet-Loss
    - Firebox Info: AntiVirus (GAV) Version, Intrusion Protection System (IPS) Version, Application Control Enabled (disabled/not working), High Availability Enabled
    - Cluster Info: Cluster Synchronisation Status, Member Roles, Member Health, Member Serial
    - Network Info: Active Connections, Connection Rate, Inbound/Outbound Traffic
    
    ITEM-TRIGGERS:
    - Cluster: Member Sync Issues, Member Health, Cluster HA Required, HA Event Detection
    - GAV/IPS Version Check Failure > Disbaled/NotInstalled/NotUpdating
    - High no of concurrent connections > Possible DDoS Attack
    
    DISCOVERY ITEMS:
    - BoVPNs: Status, Bytes In/Out, Errors In/Out
    - Gateway VPNs (disabled/not available): Status, Bytes In/Out, Errors In/Out
    - Processors: Processor Type, CPU utilisation
    - Disks: File-system Description, Total/Used space 
    - Fan Sensors (disabled/not available): Status, Speed
    - Interfaces: Status, Bytes In/Out, Errors In/Out
    - Temperature Sensors (disabled/not available)
    - Power Supplies (disabled/not available)
    
    DISCOVERY ITEM-TRIGGERS:
    - BoVPN: Status Changed, In/Out Error above threshold
    - Processor: Utilisation over threshold
    - Disk: Utilisation above threshold (low/high)
    - FANs: Status Alert, Low Fan Speed
    - Interfaces: Status Changed
    - Gateway VPN: Status Changed, In/Out Error above threshold
    - Temperature: Above threshold (high/critical)
    - Power: Status Changed
    
    + Graphs and Dashboards (Useful)

    TESTED ON:
    - Firebox M400 running v12+ firmware 
    - Clustered and non-clustered firebox units
    
    Inspired by original works of: Ticau Tudor / @tudorticau
    Re-written and expanded significantly by: Simon Jackson / @sjackson0109