Is there not a command for "Lights Out", if not can it be added?

[Surfingserenity]

I just discovered commands and I can't seem to find one for for "Lights Out"?
If there isn't one yet can it be added @rsjaffe?
I've made an amazing button with commands that makes getting an accurate crop angle and doing fine adjustments is very simple and all it needs to be complete is a "Lights Out" command.

Currently I've set Command 1 to a button with (CropOverlay,Fine8) and it Enters Crop Mode + enables Fine Correction 8x so you can accurately adjust the crop angle and also do any small picture specific tone adjustments after the bulk sync settings were done at the start of the edit - this also benefits from the "Fine Correction 8x" to allow very subtle and accurate tone controls.

[Surfingserenity]

Bump, this would be such a great feature to have.

[Surfingserenity]

Bump

[antzpantz]

Don't bump. There's a keyboard shortcut for Light modes.

…

On Sun, 18 May 2025 at 22:00, Surfingserenity ***@***.***> wrote: Bump — Reply to this email directly, view it on GitHub <#826 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AFIYPFHRTBOSIWGOMTLJQUD27CG6VAVCNFSM6AAAAAB434CKCKVHI2DSMVQWIX3LMV43URDJONRXK43TNFXW4Q3PNVWWK3TUHMYTGMJYGQ2DMNA> . You are receiving this because you are subscribed to this thread.Message ID: ***@***.***>

[Surfingserenity]

Thanks for the reply, I'm well aware of the keyboard shortcut but as per the OP I am looking for a command for the lights out modes. Seems there may not be one but I thought best to ask because I may have missed it in the massive list of commands available.

[rsjaffe]

Adobe doesn't have anything in the API to access lights-out mode, which is why there's no specific command. You have to program in the keyboard shortcut. Note that you can add a keyboard shortcut command to a series of commands, so you can have it work in your case you've described above.

[Surfingserenity]

Thanks @rsjaffe, I didn't realise you could combine keyboard shortcuts to Series of commands, that works.

Is there perhaps a way to use the series of commands to cancel the "lights-out mode" when pressing the assigned midi button again once I am finished using the Series of commands?
As it is now when you press the midi button again it cancels Crop Mode and Fine Correction 8x but it applies full lights-out mode rather than just cancelling it.