This ESPHome configuration provides local control for Atomberg fans with Tuya-based WiFi modules (TYWE1S), enabling integration with Home Assistant while maintaining all original remote functionality.
- 🌀 Full fan control (on/off, speed 1-6 including boost)
- 💡 LED control (on/off)
- 📶 WiFi signal monitoring
- 🔄 Automatic ON after power cycle helps mimmics a regular fan
Only ground can be soldered in the given pads (marked in red). None of the other pads here works!
The pins IO0, 3.3V, TX, RX should be soldered directly to the MCU as shown in the pinout. Don't forget to gnd GPIO0 (IO0) for taking the MCU into flash mode :)
Happy flashinggggg ;)