wirelesssgx-router

Short Guide to setting up Internet Access Router LAN using wireless@SGx ( or similar networks with EAP )

Use Case

It is often helpful to set up a LAN for networking purposes. However, we may not be able to access a dedicated WAN, as

1. The LAN may need to be portable ( uproot and deploy )
2. May not have access to WAN ( new environment )

A improvised WAN can be used. OpenWRT is Open Source router software offering following configurations of interest:

1. Dual Modem Routers: 1x uplink to wifi, 1x Access Point
2. Router with USB Port: 1x Usb Tethering from Phone to LAN

We document here configuration 1, where uplink is to wireless@SGx or equivalent EAP networks.

Caveats

This configuration may not be most optimal ( there are potentially redundant configurations ) and need to be further tailored for your deployment. Understanding of networking and security is required.

Generate Credentials

1. goto: https://eservice.imda.gov.sg/wirelessSGx/
2. Select Device without local sim > Android / ChromeOS
3. Generate Credentials

Installation

1. Setup OpenWRT Router and flash firmware: https://openwrt.org/
2. Connect router to internet ( For example, connect to existing Linux machine and set up LAN Network Sharing )
3. SSH to OpenWRT Router ( ssh [email protected] )
4. opkg update, opkg install wpad ( you may need to uninstall conflicting packages like wpad-openssl ). wpad is needed for support for EAP authentication.
5. reboot

Configuration

1. Set up luci and configure router settings as desired.
2. Configure the following additional router settings: