Need help with Bed Tramming.

[dbrannon79]

Hello, I just built firmware for a Creality CR-10 clone which I installed a 4.2.7 board and the Ender 3 v2 screen. all seems to be working fine except for the tramming wizard. physical bed size is 300x300 and height I have set to 380 even though it can make it up to 400. I limited the height due to the direct drive extruder and cables. When I start the tramming wizard the bl touch will probe a square pattern at a max of 220x220. I am wondering if I missed something in the configuration.h file.

I have attached my build files in a zip format if you need to take a look at them. in the configuration.h every edit I made has my initials "DAB" so you can easily search and find what I changed after using the special configurations application.

Any help would be much appreciated.

Ender3V2-300x300x380-427-BLTUBL-TJC-HomeOffs-IS-LA-MPC-Speaker.zip

[dbrannon79]

Update: Idk if it changed it's mind or what happened but I decided to run the auto build mesh and see what it did. after that I tried the tramming once again and it's now tramming the entire bed! the only thing I noticed is when it probes the left rear corner it does not display the measurement on the screen for that corner, it seems to pause a second and then shows which corner needs to be adjusted. on my Ender 3 V2 running the same firmware it does display all 4 measurements before showing the tramming differences in green.

[mriscoc]

Check: https://github.com/mriscoc/Ender3V2S1/wiki/Calibration-Guides

[mriscoc]

Also HomeOffsets is not supported when UBL is enabled.