Replies: 2 comments 3 replies
-
I'll install it and try to figure out why it doesn't work. The question is, if MSHV uses the same WSJTX protocol, if this is not MSHV's issue. |
Beta Was this translation helpful? Give feedback.
0 replies
-
Richard, Do I understand correctly that you do not see CQ spots in the QLog WSJTX CQ window when you have MSHV connected? I have tested that CQ spots are correctly received from MSHV by QLog. I have installed HSHV v2.69 and I can see the CQ-traffic in QLog. |
Beta Was this translation helpful? Give feedback.
3 replies
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
Uh oh!
There was an error while loading. Please reload this page.
Uh oh!
There was an error while loading. Please reload this page.
-
Hi!,
WSJT-X and JTDX are fully compatible when used with QLog.
From time to time I also use MSHV http://lz2hv.org/mshv on FT8 and FT4. Logging and UDP forwarding works fine using MSHV with QLog.
But now show of CQ traffic in QLog WSJT Window.
I suspect this has to do with MSHV using different mode identifiers than WSJT-X and JTDX.
This was easily solved in cqrlog a year ago, adding a few lines to the code.
Se my message in cqrlog forum https://www.cqrlog.com/node/3249
Could this be done in QLog too?
73 de LB2EG Richard
Beta Was this translation helpful? Give feedback.
All reactions