Waveshare Zero + Mosky Dual Switch Project

[rmenes]

Follow my other project, where I fit a Waveshare Zero on a Mosky Dual Switch, drilled 2 additional holes and added MIDI TRS and 9v Power.

I used a cheap 9v to 5v board from aliexpress to make the conversion.
Link is here: https://pt.aliexpress.com/item/1005006486270630.html?spm=a2g0o.order_list.order_list_main.47.7829caa4lqEsiM&gatewayAdapt=glo2bra

Photos

Video

https://youtu.be/HyErpog0Rss

[rmenes]

I was able to use two m-vave chocolates connected to the tonex one, one using bluetooth, another using TRS MIDI
The one connected through Bluetooth is changing presets, and the one through TRS MIDI is sending MIDI CC Messages to turn on and off the effects.

[Fozziemusic]

This looks great, I might try and do something similar with a Hotone FS1 switch. Is there any issue with bluetooth or wifi connection/range using a metal enclosure? Or did you remove or alter the metal casing for this reason?

[bakarasche]

I have implemented Greg Controller on FS1 on several platforms.
Waveshare ESP32S3zero is not available because it does not have wireless certification in my country.
I have tried M5stampS3 and Xiao ESP32S3 which are wireless authentication platforms in my country.
　＊A little bit of code modification (pin assignments, etc.) is needed.

Both of them can connect wirelessly in a metal case for a short distance.
The XiaoESP32S3 I am currently using can be connected to an antenna. When the included antenna sheet is placed inside the metal case, the reachable distance is about 20~30cm for Bluetooth and 1m for Wifi.
If you want to extend the reach, you can mount an optional antenna unit in the case.

https://www.seeedstudio.com/2-4GHz-2-81dBi-Antenna-for-XIAO-ESP32C3-p-5475.html